Figure 13: Product Mounted On Single-Pos Stand; Figure 14: Cable Routing On Single-Pos Stand - HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual

Information for OEM and Setup users | Mounting
2.2.1 Mounting on Single-Pos stand
You can fasten the Single-Pos stand to the product at a 20° angle.
Use the provided M4 x 8 ISO 14581 countersunk head screws to fasten the stand
to the upper VESA 100 threaded holes on the rear panel
Comply with the permissible tightening torque of 2.6 Nm
Fasten the stand with two suitable screws from above to a supporting surface
or
Attach self-adhesive rubber pads to the underside of the stand
Route the cables from behind through the opening in the stand and then to the
connections
Figure 13: Product mounted on Single-Pos
stand
Further information: "Product dimensions with Single-Pos stand", Page 216
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Figure 14: Cable routing on Single-Pos
stand
II
65