HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 102

II
Adjusting an existing table of supporting points
After a table of supporting points for segmented linear error compensation has been
created, this table can then be modified as needed.
Settings ► Axes ► <Axis name> ► Error compensation ►
Segmented linear error compensation (SLEC)
Further information: "Configuring segmented linear error compensation (SLEC)",
Page 100
102
Use the ON/OFF slide switch to deactivate the Compensation
function
Tap Table of supporting points
The table lists the supporting point positions (P) and the
compensation values (D) of the individual segments
Adjust the compensation value (D) for the supporting points
Confirm the entries with RET
To switch to the previous display, tap Back
Activate Compensation with the ON/OFF slide switch
The adjusted error compensation for the axis is applied
Information for OEM and Setup users | Commissioning
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022