HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 269

Information for the Operator user | Application example
Tool table
For the example it is presumed that the tools for machining are not yet defined.
You must add in advance all of the tools to be used to the tool table.
Further information: "Creating a tool table", Page 166
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Tap Tools on the status bar
The Tools dialog box appears
Tap Open table
The Tool table dialog box appears
Tap Add
Enter the designation Finishing tool in the Tool type input
field
Confirm your input with RET
Enter the value 0 in the X input field
Confirm your input with RET
Enter the value 0 in the Z input field
Confirm your input with RET
The defined finishing tool is added to the tool table
Repeat this process for the other tools
Tap Close
The Tool table dialog box is closed
III
269