HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 207

Information for OEM and Setup users | Servicing and maintenance
8.7.3
Restore settings
Backed-up settings can be restored to the product. The current configuration of the
product is replaced in the process.
Software options that were active when the settings were backed up
must be activated before restoring the settings.
A restore can be necessary in the following cases:
During commissioning, the settings are set on a product and transferred to all
identical products
Further information: "Steps for commissioning", Page 83
After a reset, the settings are copied back to the product
Further information: "Reset all settings", Page 208
Settings ► Service ► Back up and restore
Parameter
Restore settings
Safely removing a USB mass storage device
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Explanation
Restoring of the backed up settings
Restore settings
Tap Complete restoration
If required, connect a USB mass storage device (FAT32
format) to a USB port on the product
Navigate to the folder containing the backup file
Select the backup file
Tap Select
Confirm the successful transfer with OK
The system is shut down
To restart the product with the transferred configuration data,
switch the product off and then back on
Tap File management in the main menu
Navigate to the list of storage locations
Tap Safely remove
The message "The storage medium can be removed now."
appears
Disconnect the USB mass storage device
II
207