HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 185

Information for OEM and Setup users | Settings
Parameter
Vertical alignment
The Undo buttons enable the color definitions of the simulation window
to be reset to factory settings.
7.2.5
Sounds
Settings ► General ► Sounds
The available sounds are grouped into categories. The sounds differ within a
category.
Parameter
Speaker
Speaker volume
Message and Error
Touch tone
7.2.6
Printers
Settings ► General ► Printers
The current firmware of the units in this series does not support this
function.
7.2.7
Copyrights
Settings ► General ► Copyrights
Parameter
Open source software
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Explanation
Vertical orientation of the coordinate system in the simulation
window
Settings:
Upward: Values increase in the upward direction
Downward: Values increase in the downward direction
Default value: Upward
Explanation
Use of the built-in speaker on the rear panel of the product
Settings: ON or OFF
Default setting: ON
Volume of the product's speaker
Setting range: 0 % ... 100 %
Default setting: 50 %
Sound to be played when a message is displayed
When you select a setting, the associated sound is played
Settings: Standard, Guitar, Robot, Outer space, No sound
Default setting: Standard
Sound to be played when using a touch element
When you select a setting, the associated sound is played
Settings: Standard, Guitar, Robot, Outer space, No sound
Default setting: Standard
Meaning and function
Display of the licenses of the software used
II
185