HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 111

Information for OEM and Setup users | Commissioning
Parameter
Kv factor L
Maximum positioning error
Maximum standstill error
Positioning window
Positioning window in NC mode
Minimum dwell time in manual
positioning window
Minimum dwell time in position-
ing window
Start-up time
The start-up time allows you to control the acceleration behavior and the braking
behavior of the axes. The start-up time always refers to f
f
Hochlaufzeit
f
max
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Explanation
Proportional component of the position controller during stand-
still; effective during positioning to target position as soon as the
Positioning window in NC mode has been reached and with axis
clamping (hold the axis at its position)
Setting range: 0.3 m/(min x mm) ... 6 m/(min x mm)
Default value: 2.5
Definition of the maximum following error during positioning
Setting range: 5 µm ... 1000 µm
Default value: 500
Definition of the maximum position deviation at standstill
Setting range: 5 µm ... 1000 µm
Default value: 100
Input of the scaling factor for the positioning aid in MDI mode
(only for manually operated linear axes)
Setting range: 0.020 mm ... 2.000 mm
Default value: 0.100
The entered range around the target point. This area is the switch-
ing point to the Kv factor L
The entered required amount of time for the axes to be in the
positioning window until the block is completed (only for manually
operated linear axes)
Setting range: 0 ms ... 10000 ms
Default value: 0 ms
The entered required amount of time for the axes to be in the
positioning window until the block is completed
Setting range: 0 ms ... 10000 ms
Default value: 0 ms
.
max
Rücklaufzeit
(= Hochlaufzeit)
t
111
II