HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 108

II
Movement detection
Settings ► Axes ► General settings ► Central drive ► Movement detection
Parameter
Movement detection
Umax
Start-up time
Minimum traverse for movement
detection
Minimum rotation angle for
movement detection
Timeout for abort of active
movement detection
Stop on movement of non-
controlled axes
108
Information for OEM and Setup users | Commissioning
Explanation
Selection of whether movement detection is to be performed
when the axis starts moving
Settings:
ON: Movement detection is activated
OFF: Access to the central drive can only be implemented via
digital enabling signals of the individual axes
Default value: OFF
Voltage that is output at the analog output in order to detect the
direction of movement
Setting range: 10 mV ... 1000 mV
Default value: 900
Configuration of the acceleration behavior of the axes during start-
ing for movement detection; the value of the of the start-up time
must be matched with Umax
Setting range: 5 ms ... 2880 ms
Default value: 50
Starting from this threshold value, the movement detection
assumes a linear movement
Setting range: 0.005 mm ... 2.000 mm
Default value: 0.05
Starting from this threshold value, the movement detection
assumes a rotational movement
Setting range: 0.005 ° ... 45.000 °
Default value: 0.5
If no movement is detected after this time limit has expired,
the movement detection is aborted with a corresponding error
message
Setting range: 0.1 s ... 50 s
Default value: 5
Settings:
ON: If the movement detection ascertains a movement of an
axis that should not be traversed, the process is stopped with
a corresponding error message; only axes to which a central
drive has been assigned are monitored
OFF: The movement detection monitors only the axis that
is to be moved. All of the other axes can move freely during
movement detection
Default value: OFF
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022