HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 191

Information for OEM and Setup users | Settings
7.5
Axes
This chapter describes settings for configuring the axes and assigned devices.
Not all of the described parameters and options may be available,
depending on the product version, configuration and the connected
encoders.
General settings
Settings ► Axes ► General settings
Parameter
Reference marks
Information
Switching functions
Inputs (Switching functions)
Outputs (Switching functions)
Overrides
M functions Adding
M functions Configuring
Diameter axis
Special settings
Central drive
Virtual axis keys
Thread cutting
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Further information
"Reference marks", Page 138
"Information", Page 193
"Switching functions", Page 120
"Inputs (Switching functions)", Page 120
"Outputs (Switching functions)", Page 122
"Overrides", Page 122
"Configuring M functions", Page 139
"Configuring M functions", Page 139
"Diameter axis", Page 136
"Special settings", Page 123
"Configuring the central drive", Page 103
"Configuring virtual axis keys", Page 124
"Configuring thread cutting (NC software option)", Page 137
II
191