HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 85

Information for OEM and Setup users | Commissioning
4.4 Selecting the Application
When putting the product into service, you can choose between the standard
application modes of Milling and Turning.
In its factory default setting, the product is already set to the Milling application
mode.
When you change the unit's application mode, then all of the axis settings
will be reset.
Settings ► Service ► OEM area ► Settings
Parameter
Application
4.5 Basic settings
4.5.1 Activating Software options
You can activate additional Software options via a License key.
You can view the enabled Software options on the overview page.
Further information: "Checking the Software options", Page 87
Requesting license key
You can request a license key by using the following procedure:
Reading out device information for the license key request
Creating a license key request
Reading out device information for the license key request
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Explanation
The type of application mode; a change becomes active after a
restart
Settings:
Milling
Turning
Default value: Milling
Tap Settings in the main menu
Tap General
Tap Device information
An overview of the device information appears
The product designation, ID number, serial number, and
firmware version are displayed
Contact a HEIDENHAIN service agency and submit the
displayed device information in order to request a license key
for the product
The license key and the license file are generated and sent by
e-mail
II
85