Overview; Figure 55: Example Workpiece - HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual

III
5.1

Overview

This chapter describes the production of an example workpiece. This chapter will
guide you step by step through the unit's various machining options as you machine
the example workpiece. For successful machining of the stud bolt you will need to
perform the following machining steps:
Machining step
Setting up the lathe
Roughing the outside contour
recess
Turning the chamfer
Finishing the outside contour
Thread cutting
Requirements:
X axis as NC axis
Z axis as NC axis
Rotational axis as NC axis or spindle
with orientation

Figure 55: Example workpiece

266
Make sure that you have read and understood the "Basic operation"
chapter before carrying out the actions described below.
Further information: "Basic operation", Page 18
Information for the Operator user | Application example
Mode of operation
Manual operation
Manual operation
Manual operation
Manual operation
Manual operation
MDI mode
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022