HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 183

Information for OEM and Setup users | Settings
7.2.3
Display
Settings ► General ► Display
Parameter
Position display
Position values
Distance-to-go indicator
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Explanation
Configuration of the position display in the MDI mode and
Program Run operating mode. The configuration also determines
the actions requested by the wizard in the MDI and Program Run
operating modes:
Position with distance to go: The wizard prompts you to
move the axis to the displayed position.
Distance to go with position: The wizard prompts you to
move the axis to 0, and a positioning aid is shown.
Settings:
Position: The position is displayed in large digits
Position with distance to go: The position is displayed in
large digits and the distance to go in small digits
Distance to go with position: The distance to go is displayed
in large digits, and the position in small digits
Default setting: Distance to go with position
The position values can describe the actual values or nominal
values of the axes.
Settings:
Actual value
Nominal value
Default setting: Actual value
Display of the distance-to-go indicator in MDI mode
Settings: ON or OFF
Default value: ON
II
183