Checking A Program In The Simulation Window; Managing Programs; Opening A Program; Closing A Program - HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual

Information for the Operator user | Programming
4.4.3

Checking a program in the simulation window

4.5

Managing programs

After you have created a program, you can save it for automatic program run or
subsequent editing.
The default storage location for programs is Internal/Programs.
4.5.1

Opening a program

4.5.2

Closing a program

4.5.3

Saving a program

4.5.4

Saving a program under a new name

HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Tap Graphic
The simulation window for the current program appears
Tap each program block, one after the other
The program steps are displayed in the simulation window;
you can enlarge the detail view as needed
To enlarge the view, tap Detail view
To return to the overview view, tap Overview
Tap Open program in the program management
Select the storage location in the dialog, e. g.
Internal/Programs or USB mass storage device
Tap the folder containing the file
Tap the file
Tap Open
The selected program is loaded
Tap Close program in the program management
The opened program is closed
Tap Save program in the program management
The program is saved
Tap Save program as in the program management
In the dialog, select the storage location, e. g.
Internal/Programs or USB mass storage device, in which you
want to save the program
Enter a name for the program
Confirm the entry with RET
Tap Save as
The program is saved
The name of the program is displayed on the toolbar
III
263