Executing Blocks - HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual

Information for the Operator user | MDI mode
Parameter
Feed rate in X
Air cuts
2.4

Executing blocks

You can execute a positioning function and execute this block.
If enabling signals are missing, the running program is halted and the
drives of the machine are stopped.
Further information: Manufacturer's documentation for the machine
Executing blocks
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Description
Feed rate for downfeed to thread depth
Number of air cuts at the end (0 – 10)
Tap Create on the status bar
A new block is displayed
or
The last programmed MDI block is loaded along with all of its
parameters
Select the desired block type from the Block type drop-down
list
Based on the block type, define the relevant parameters
To load the current axis position, tap Actual position capture
in the appropriate input fields
Confirm each input with RET
To execute the block, tap END
The positioning aid is displayed
If the simulation window is activated, the current block is
visualized
Depending on the block, user intervention may be required; the
wizard will display the relevant instructions
Follow the instructions in the wizard
If you are using NC-controlled axes, then tap or press NC
START on the product or machine tool
III
239