HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 40

I
Symbol
+Z
1
3.9.2 Position display functions
Coupling axes
You can alternatingly couple the display of the axes Z and Zo. For coupled axes, the
position display shows the sum of the position values of both axes.
40
Meaning
Zo axis is coupled with the Z axis. Position display shows the
sum of both position values
Further information: "Coupling axes", Page 40
Z axis is coupled with the Zo axis. Position display shows the
sum of both position values
Selected gear stage of the gear spindle
Further information: "Setting the gear stage for gear
spindles", Page 42
Spindle speed cannot be achieved with selected gear stage
Select a higher gear stage
Spindle speed cannot be achieved with selected gear stage
Select a lower gear stage
The CSS (constant surface speed) spindle mode is activated
Further information: "Setting the spindle mode", Page 43
If the icon is flashing, then the calculated spindle speed lies
outside of the defined speed range. The desired surface
speed cannot be attained. The spindle will continue to turn at
the maximum or minimum speed
In MDI mode and Program Run , a scaling factor is applied to
the axis
Further information: "Adjusting settings in the quick access
menu", Page 45
Axis is feedback-controlled
Actual spindle speed
Input field for controlling the spindle speed
Further information: "Setting the spindle speed", Page 41
Virtual axis keys for operating NC axes
If the Z axis and the Zo axis have been coupled, the Program run
operating mode is disabled.
Coupling is identical for the Z axis and Zo axis. The following describes
only the coupling of the Z axis.
All of the other axes can be coupled in the menu.
Further information: "Coupling axes", Page 135
General information | Basic operation
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022