HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 126

II
Spindle axis S
Settings ► Axes ► Spindle axis S
Parameters
Axis name
Axis type
Encoder
Error compensation
Outputs
Inputs
Gear stages
Gear stage selection through an
external signal
Start-up time for upper spindle
speed range
Start-up time for lower spindle
speed range
Break point of characteristic
curve for start-up times
126
Information for OEM and Setup users | Commissioning
Explanation
Definition of the axis name displayed in the position preview
Settings:
S
Default setting: S
Definition of the axis type
Settings:
Not defined
Spindle
Gear spindle
Spindle with orientation
Configuration of the connected encoder
Further information: "Overview of typical encoders", Page 91
Configuration of the linear error compensation LEC or segmented
linear error compensation SLEC
Further information: "Performing error compensation", Page 98
Configuration of the Outputs for the spindle
Further information: "Outputs (S)", Page 127
Configuration of the Inputs for the spindle
Further information: "Inputs (S)", Page 130
Configuration of the Gear stages for the Gear spindle
Further information: "Gear stages", Page 133
Selection of the Gear stages of the Gear spindle through exter-
nal signals. To be able to switch the Gear stages, DC 24 V must
be present at X105.17/18/36
Settings
ON: The Gear stages are selected via external signals
OFF: The Gear stages are selected manually in the operating
modes
Default value: OFF
Setting the Start-up time from standstill to the maximum spindle
speed Smax for the upper spindle speed range
Setting range: 50 ms ... 10000 ms
Default value: 500
Setting the Start-up time from standstill to the maximum spindle
speed Smax for the lower spindle speed range
Setting range: 50 ms ... 10000 ms
Default value: 500
Definition of the limit between the upper and the lower spindle
speed range. The value of the start-up time must be matched to
Smax
Setting range: 0 rpm ... 2000 rpm
Default value: 1500
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022