HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 131

Information for OEM and Setup users | Commissioning
Movement commands from digital input (S)
Settings ► Axes ► S ► Inputs ►Movement commands from digital input
Parameter
Enable digital movement
commands
Spindle start
Spindle stop
Digital enable inputs (S)
Settings ► Axes ► S ► Inputs
Parameter
Spindle ready
Spindle interrupt
Spindle protection device
Spindle sleeve final position +
Spindle sleeve final position –
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Explanation
Use of the digital movement commands
Settings: ON or OFF
Default value: OFF
Assignment of the digital input for the spindle start according to
pin layout
Default value: Not connected
Assignment of the digital input for the spindle stop according to
pin layout
Default value: Not connected
►
Digital enable inputs
Explanation
Assignment of a digital input; indicates that the spindle is in
reliable condition
Default value: Not connected
Assignment of a digital input; in active state it immediately discon-
nects from power the configured analog output of the spindle. A
spindle movement is stopped without a ramp, axes with automat-
ic traverse are stopped if applicable and spindle activation is
prevented.
The machine tool builder is responsible for the
immediate stopping of the spindles.
Default value: Not connected
Assignment of a digital input; indicates whether an existing
spindle protection device is open or closed. This signal influences
error messages and program run.
The machine tool builder is responsible for the
immediate shutdown of the spindles with opened
spindle protection.
Default value: Not connected
Assignment of a digital input for the upper limit switch of the
sleeves. The input is used for reversing the spindle with thread
cutting
Default value: Not connected
Assignment of a digital input for the lower limit switch of the
sleeves. The input is used for reversing the spindle with thread
cutting
Default value: Not connected
II
131