HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 45

General information | Basic operation
Operating element
3.10.2 Adjusting settings in the quick access menu
With the quick access menu, you can adjust the following settings:
The availability of settings in the quick access menu depends on which
user is logged in.
Unit for linear values (Millimeters or Inch)
Unit for angular values (Radian, Decimal degrees or Deg-Min-Sec)
The display of Radial machining axes (Radius or Diameter)
The Scaling factor by which the stored position is multiplied during execution of
an MDI block or program block
Setting units
Activating the display of Radial machining axes
X
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Function
Override
Display of the changed traversing speed of the fastest linear
axis.
If all linear axes are at a standstill, the changed traversing
speed of the fastest rotational axis is displayed
The change is made using an external controller on an NC-
controlled machine tool
Auxiliary functions
Auxiliary functions in Manual operation mode
Further information: "Additional functions in Manual
operation mode", Page 48
MDI block
For creating machining blocks in MDI mode
Tap the quick access menu on the status bar
Select the desired Unit for linear values
Select the desired Unit for angular values
Tap Close to close the quick access menu
The selected units are displayed in the quick access menu
Tap the quick access menu on the status bar
Select the desired option
Tap Close to close the quick access menu
If the Diameter option is selected, then the corresponding
symbol appears in the position display
I
45