Creating A Program; Programming Support; Figure 53: Example Of A Program In The Programming Operating Mode - HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual

Information for the Operator user | Programming
Parameter
Feed rate in X
Air cuts
4.3

Creating a program

A program always consists of a program header and a sequence of blocks. You
can define various block types, edit the associated block parameters, and delete
individual blocks from the program.
1

Figure 53: Example of a program in the Programming operating mode

1 View bar
2 Simulation window (optional)
3 Block parameters
4 Toolbar
5 Program blocks
6 Program management
4.3.1

Programming support

The product provides the following features to assist you in creating programs:
When you add a block, the wizard displays information on the parameters that
are required for the selected block type.
If a block contains errors or undefined parameters, it is displayed in red type in
the list.
If problems occur, the wizard displays the message The program contains
incomplete program blocks. You can switch between program blocks by
tapping the arrow keys.
The optional simulation window shows a visualization of the current block.
Further information: "Using the simulation window", Page 240
All changes to a program can be automatically saved.
Tap Save program automatically in the program management
All changes will be automatically saved immediately
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Description
Feed rate for downfeed to thread depth
Number of air cuts at the end (0 – 10)
2 3
6
4
5
259
III