HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 94

II
Parameter
Encoder model
Signal period
Line count
Teach sequence
Display mode
Mechanical ratio
Reference marks
Analog filter frequency
Terminating resistor
94
Information for OEM and Setup users | Commissioning
Explanation
Connected encoder model
Settings:
Linear encoder: Linear axis
Angle encoder: Rotary axis
Angle encoder as linear encoder: Rotary axis is displayed as
linear axis
Default value: Depending on the connected encoder
For linear encoders
Length of a signal period
Setting range: 0.001 µm ... 1000000.000 µm
Default value: 20.000
For angle encoders and for display of a rotary axis as a linear axis.
Number of lines
Setting range: 1 ... 1000000
Default value: 1000
Starts the teach sequence for determining the Line count for an
angle encoder based on a specified angle of rotation.
For angle encoders and for the display of a rotary axis as a linear
axis.
Settings:
- ∞ ... ∞
0° ... 360°
-180° ... 180°
Default value: - ∞ ... ∞
For display of a rotary axis as a linear axis:
traverse path in mm per revolution
Setting range: 0.1 mm ... 1000 mm
Default value: 1.0
Configuration of the Reference marks
Further information: "Reference marks (Encoder)", Page 96
Frequency value of the analog low-pass filter
Settings:
33 kHz: Suppression of interference frequencies above 33 kHz
400 kHz: Suppression of interference frequencies above
400 kHz
Default value: 400 kHz
Dummy load to avoid reflections
Settings: ON or OFF
Default value: ON
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022