Overview - HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual

Information for the Operator user | Program run
3.1

Overview

This chapter describes the Program run operating mode and how to execute a
previously created program in this mode.
Make sure that you have read and understood the "Basic operation"
chapter before carrying out the actions described below.
Further information: "Basic operation", Page 18
Short description
In the Program run operating mode, you use an already created program for part
production. It is not possible to change the program in this operating mode, but you
can check in Single Block mode when running the program.
Further information: "In Single block mode", Page 248
The execution of the program run may vary depending on the machine tool and the
product version:
If the machine tool has NC-controlled axes, and the product uses a
POSITIP 8000 NC1 software option, then the parameters for positioning
movements are transferred directly to the machine tool.
The individual steps are initiated via the NC START key on the machine tool.
If the machine tool does not have any NC-controlled axis, then the you must
perform positioning movements manually using the handwheel or the manual
direction key.
During execution of a program, the wizard guides you through the individual program
steps. The optional simulation window can serve as a graphical positioning aid for
the axes you need to move.
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
III
245