HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 112

II
Kv factor P, Kv factor L and Positioning window in NC mode
The diagram below shows the relationship between the two parameters Kv factor P,
Kv factor L and the Positioning window in NC mode.
A
The Kv factor P is effective for the traverse path. As soon as the nominal values
of the position controller that are calculated from the acceleration ramps reach the
Positioning window in NC mode, this triggers a switchover to the Kv factor L. The
target position is transferred to the position controller as the new nominal value.
HEIDENHAIN recommends that the two Kv factors not be set too far apart.
Outputs
In the settings for the outputs, you can configure your motor. Depending on the type
of motor, you have to make different settings.
Settings ► Axes ► X, Y ... ► Outputs
Parameters
Type of motor
112
Information for OEM and Setup users | Commissioning
Umschaltpunkt
Kv-Faktor P
Verfahrweg
Explanation
Selection of the motor type
Settings:
Bipolar servo motor: -10 V ... 10 V
Unipolar servo motor: 0 V ... 10 V
Stepper motor
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Positionierfenster
im NC-Betrieb
Kv-Faktor L
B