HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 73

Information for OEM and Setup users | Installation
1 X102: 37-pin D-sub connection for digital TTL interface (8 inputs, 16 outputs)
2 X112: 15-pin D-sub connection for touch probes (e.g. HEIDENHAIN touch probe)
3 X1-X6: 15-pin D-sub connections for encoder with interfaces of the type 1 V
or EnDat 2.2
Four inputs enabled by default, with option of enabling another two inputs
4 X32-X34: USB 2.0 Hi-Speed connection (Type-A) for USB mass storage device
5 Speaker
6 Functional ground connection as per IEC/EN 60204-1
7 X116: RJ45 Ethernet connection for communication and data exchange with
downstream systems or PC
X117: Not currently supported
11 X100: Power switch and power connection
Additional connections on devices with ID 1089177-xx:
8 X106: 15-pin D-sub connection for analog interface (4 inputs, 4 outputs)
9 X104: 9-pin D-sub connection for universal relay interface (2x relay changeover
contacts)
10 X105: 37-pin D-sub connection for digital interface (DC 24 V; 24 switching inputs,
8 switching outputs)
Left side panel
12 X31 (under protective cover): USB 2.0 Hi-Speed connection (Type-A) for USB mass
storage device
3.4 Connecting encoders
For encoders with an EnDat 2.2 interface: If the corresponding encoder
input has already been assigned to an axis in the device settings, then
the encoder is automatically detected upon restart, and the settings are
adapted. Alternatively, you can assign the encoder input after you have
connected the encoder.
Comply with the pin layout
Remove and save the dust protection cap
Route the cables depending on the mounting variant
Further information: "Assembly of the product", Page 64
Connect the encoder cables tightly to the respective connections
Further information: "Device overview", Page 71
If the cable connectors include mounting screws, do not overtighten them
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
, 11μA
PP PP
II
73