HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 127

Information for OEM and Setup users | Commissioning
Parameters
Minimum spindle speed
Maximum spindle speed for
oriented spindle stop
Maximum spindle speed for
thread cutting
Maximum spindle speed in
positioning mode
Start-up times of a spindle
The Break point of characteristic curve for start-up times value divides the
spindle speeds into two ranges. For each range you can define an individual start-up
time:
Start-up time for upper spindle speed range: Time within which the motor
accelerates from standstill to the maximum speed Smax
Start-up time for lower spindle speed range: Time within which the motor
accelerates from standstill to the maximum speed Smax
Outputs (S)
In the settings for the outputs, you can configure your motor. Depending on the type
of motor, you have to make different settings.
Settings ► Axes ► S ► Outputs
Parameters
Type of motor
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Explanation
Definition of the minimum spindle speed
Setting range: 0 rpm ... 500 rpm
Default value: 50
Definition of the maximum spindle speed for oriented spindle stop
Setting range: 0 rpm ... 500 rpm
Default value: 30
To use the function, you have to assign an input to the
Spindle position parameter.
Further information: "Inputs (S)", Page 130
Setting the maximum spindle speed for thread cutting during
tapping
Setting range: 100 rpm ... 2000 rpm
Default value: 1000
Setting the maximum spindle speed in controlled operation for the
Thread Cutting machining cycles in the Turning application
Setting range: 100 rpm ... 200 rpm
Default value: 1500
Explanation
Bipolar servo motor: -10 V ... 10 V
Unipolar servo motor: 0 V ... 10 V
Stepper motor
II
127