HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 116

II
Inputs
Settings ► Axes ► X, Y ... ► Inputs
Parameters
Movement commands from
digital input
Movement commands from
analog input
Movement commands from
electronic handwheel
Digital enable inputs
Movement commands from digital input
Settings ► Axes ► X, Y ... ► Inputs ►Movement commands from digital input
Parameter
Enable digital movement
commands
Input for digital movement
command in positive direction
Input for digital movement
command in negative direction
116
Information for OEM and Setup users | Commissioning
Explanation
Configuration of movement commands from external input
devices via the digital input
Configuration of movement commands from external input
devices via the analog input
Configuration of the movement commands from an electronic
handwheel
Further information: "Configuring an Electronic handwheel",
Page 133
Configuration of the digital inputs for the enable
Explanation
Enabling external movement commands (such as jog buttons on
the operating panel of the machine) via the digital input
Settings: ON or OFF
Default value: OFF
Digital movement commands are only available if the
analog movement commands are deactivated.
Further information: "Movement commands from
analog input", Page 117
To be able to work with external movement
commands you have to configure the following inputs:
Input for digital movement command in positive
direction
Input for digital movement command in
negative direction
Assignment of the digital input for the movement command in the
positive direction according to pin layout
Default value: Not connected
Assignment of the digital input for the movement command in the
negative direction according to pin layout
Default value: Not connected
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022