HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 123

Information for OEM and Setup users | Commissioning
Special settings
Settings ► Axes ► General settings ► Special settings
Parameters
Electronic axis clamping on axis
halt
Only single axis movement via
jog buttons
Maximum machine speed for
linear movements
Maximum machine speed for
radial movements
Rapid traverse speed for linear
movements
Rapid traverse speed for radial
movements
Velocity feedforward control for
position feedback control
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Explanation
Setting for electronic axis clamping when the axis is at a standstill
Settings:
ON: The axis is clamped on standstill of the axis
OFF: The axis is not clamped on standstill of the axis
Default value: OFF
Definition of the axis movements that are possible with the
traverse keys
Settings:
ON: Only a single axis can be moved
OFF: Several axes can be moved simultaneously
Default value: OFF
Definition of the maximum speed at which NC-controlled linear
axes can be moved
Setting range: 100 mm/min ... 10000 mm/min
Default value: 2000
The Maximum machine speed cannot be exceeded,
even if you have defined a higher feed rate for
individual axes.
Definition of the maximum speed at which NC-controlled rotation-
al axes can be moved.
Setting range: 72000 °/min ... 3600000 °/min
Default value: 720000
Definition of the speed at which NC-controlled linear axes are
moved at rapid traverse
Setting range: 100 mm/min ... 10000 mm/min
Default value: 2000
Definition of the speed at which NC-controlled rotational axes are
moved at rapid traverse
Setting range: 72000 °/min ... 3600000 °/min
Default value: 720000
Setting the Velocity feedforward control for position feedback
control of interpolated NC movements. Reducing the following
error directly affects the speed control loop
Settings:
None
t - 2 ms
t - 4 ms
t - 6 ms
Default value: None
II
123