HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 136

II
4.6.12
Diameter axis
If you do not wish to work with a preset table or tool table, you can activate direct
input via the axis label X.
Settings ► Axes ► General settings ► Diameter axis
Parameter
Preset setting via axis label
Consider presets with CSS
136
Information for OEM and Setup users | Commissioning
Explanation
Defines whether the direct setting of a preset via the axis label is
activated
Preset setting via the axis label can lead to
unintentional shifting of the preset away from the
center of the workpiece.
Settings:
ON: Preset setting via axis label is active
OFF: Preset setting via axis label is inactive
Default value: OFF
Defines whether the presets are considered in CSS mode
A consideration of the presets in CSS mode can lead
to CSS no longer acting on the physical center of the
workpiece.
Settings:
ON: Consideration of the presets in CSS mode is active
OFF: Consideration of the presets in CSS mode is inactive
Default value: OFF
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022