Figure 19: Product Mounted On Multi-Pos Holder; Figure 20: Cable Routing On Multi-Pos Holder - HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual

II
2.2.4 Mounting on Multi-Pos holder
Use the provided M4 x 8 ISO 14581 countersunk head screws (black) to fasten
the holder to the VESA 100 threaded holes on the rear panel
Mount the holder with the supplied M8 screw, the washers, the handle and the
M8 hexagon nut to an arm
or
Mount the holder with two screws <7 mm through the two holes to the intended
surface
Adjust the desired angle of inclination within the tilting range of 90°
To fix the holder in place: tighten the T25 screw
Route the cable from behind through the two supports of the holder and then
through the lateral openings to the connections
Figure 19: Product mounted on Multi-Pos
holder
Further information: "Product dimensions with Multi-Pos holder", Page 217
68
Comply with the permissible tightening torque of 2.6 Nm
Comply with the tightening torque for screw T25
Recommended tightening torque: 5.0 Nm
Maximum permissible tightening torque: 15.0 Nm
Information for OEM and Setup users | Mounting
Figure 20: Cable routing on Multi-Pos
holder
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022