HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 97

Information for OEM and Setup users | Commissioning
Parameters
Inversion of reference mark
pulses
Reference point displacement
Reference point displacement
Settings ► Axes ► <Axis name> ► Encoder ► Reference marks ►
Reference point displacement
Parameters
Reference point displacement
Reference point displacement
Current position for reference
point shift
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Explanation
Specifies whether the reference mark pulses are evaluated in
inverted form
Settings
ON: Reference pulses are evaluated in inverted form
OFF: Reference pulses are not evaluated in inverted form
Default value: OFF
Configuration of the offset between the reference mark and the
zero point
Further information: "Reference point displacement", Page 93
Explanation
Activation of offset calculation between reference mark and
datum of the machine
Setting range: ON or OFF
Default value: OFF
Manual input of the offset (in mm or degrees according to the
selected encoder type) between reference mark and datum
Default value: 0.00000
Apply applies the current position as an offset (in mm or degrees,
depending on the selected encoder model) between the reference
mark and the zero point
II
97