Mounting On Single-Pos Stand; Figure 2: Product Mounted On Single-Pos Stand; Figure 3: Cable Routing On Single-Pos Stand - HEIDENHAIN ND 7000 Operating Instructions Manual

Mounting | Assembly of the product
4.2.1

Mounting on Single-Pos stand

You can fasten the Single-Pos stand to the product at a 20° angle.
Use the provided M4 x 8 ISO 14581 countersunk head screws to fasten the
stand to the upper threaded holes on the rear panel
Comply with the permissible tightening torque of 2.6 Nm
Fasten the stand with two suitable screws from above to a supporting surface
or
Attach self-adhesive rubber pads to the underside of the stand
Route the cable from behind through the opening of the stand and then
through the lateral openings to the connections
Figure 2: Product mounted on Single-Pos
stand
Further information:
HEIDENHAIN | ND 7000 | Operating Instructions Milling | 01/2020
Figure 3: Cable routing on Single-Pos
stand
"Product dimensions with Single-Pos stand", Page 298
4
41