Figure 15: Product Mounted On Duo-Pos Stand; Figure 16: Cable Routing On Duo-Pos Stand - HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual

II
2.2.2 Mounting on Duo-Pos stand
You can fasten the Duo-Pos stand to the product at a 20° or 45° angle.
Use the provided M4 x 8 ISO 7380 hexagon socket screws to fasten the stand to
the lower VESA 100 threaded holes on the rear panel
Using the mounting slots (width = 4.5 mm), screw the stand to a supporting
surface
or
Set up the device freely at the desired location
Route the cable from behind through the two supports of the stand and then
through the lateral openings to the connections
Figure 15: Product mounted on Duo-Pos
stand
Further information: "Product dimensions with Duo-Pos stand", Page 216
66
Comply with the permissible tightening torque of 2.6 Nm
Information for OEM and Setup users | Mounting

Figure 16: Cable routing on Duo-Pos stand

HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022