HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 147

Information for OEM and Setup users | Commissioning
4.8.4 Adjusting the display
You can adjust the override display in the Manual operation and MDI menus. You
can also define the layout of the screen keyboard.
Adjusting the Override display
Settings ► Service ► OEM area ► Settings
Parameter
Override display
Defining the keyboard design
Settings ► Service ► OEM area ► Settings
Parameter
Keyboard theme
4.8.5 Adjusting the program execution
As an OEM you can configure the mode of program execution. For example, you can
configure M functions. If you are using a central drive, you can change the default
image for the central drive.
Program execution
Settings ► Service ► OEM area ► Settings ► Program run
Parameter
Automatic advance on reaching
upper spindle sleeve final
position
M functions
Central drive
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Explanation
Type of override display in Manual operation and MDI mode
Settings:
Percent: The override is displayed as a percentage of the set
maximum feed rate
Value: Override is displayed in mm/min
Default value: Percent
Explanation
Selection of the keyboard layout
Settings:
Standard: Entry confirmed with (Return)
TNC: Entry confirmed with (Enter)
Default value: Standard
Explanation
Automatic advance when executing hole patterns always occurs
when the upper spindle sleeve limit switch is reached
Settings: ON or OFF
Default value: OFF
For the configuration, see "Configuring M functions", Page 148
Assigning an image that is displayed during the execution of a
program run block for setting the axis direction; see "Configuring
the central drive", Page 148
II
147