HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 23

General information | Basic operation
3.4 POSITIP 8000 – switch-on and switch-off
3.4.1 Switching on the POSITIP 8000
Before using the product, you need to perform the commissioning and
setup steps. Depending on the purpose of use, you may have to configure
additional setup parameters.
Further information: "Commissioning", Page 80
Turn the power switch on
The power switch is located on the rear side of the product
The unit powers up. This can take a moment
If automatic user login is active and the last user who logged in was of the
Operator type, the user interface opens with the Manual operation menu
If automatic user login is not active, the User login menu is displayed
Further information: "User login and logout", Page 24
3.4.2 Activating and deactivating the energy saving mode
If you will not be using the unit for a while, you should activate the energy-saving
mode. This switches the unit to an inactive state without interrupting the power
supply. The screen is switched off in this state.
Activating energy-saving mode
Deactivating energy-saving mode
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Tap Switch off in the main menu
Tap Energy-saving mode
The screen switches off
Tap anywhere on the touchscreen
An arrow appears at the bottom of the screen
Drag the arrow up
The screen is switched on and shows the user interface last
displayed
I
23