II
Activating remote access for screenshots
To connect ScreenshotClient with the product via the computer you need to activate
Remote access for screenshots on the product.
Settings ► Service ► OEM area
Parameter
Remote access for screenshots
4.9
Backing up data
4.9.1
Back up settings
The product's settings can be backed up as a file so that they are available after
a reset to the factory default settings has been performed or for installation on
multiple units.
Settings ► Service ► Back up and restore
Parameter
Back up settings
Performing Complete backup
During a complete backup of the configuration, all settings of the product are backed
up.
152
Explanation
Permitting a network connection with the ScreenshotClient
program so that ScreenshotClient can take screenshots of the
unit from a computer
Settings:
ON: Remote access is possible
OFF: Remote access is not possible
Default value: OFF
Explanation
Backing up of settings of the product
Tap Complete backup
If required, connect a USB mass storage device (FAT32
format) to a USB port of the product
Select the folder to which you want to copy the configuration
data
Specify a name for the configuration data,
e.g. "<yyyy-mm-dd>_config"
Confirm the entry with RET
Tap Save as
Tap OK to confirm the successful backup of the configuration
The configuration file was backed up
Information for OEM and Setup users | Commissioning
When the unit is shut down, Remote access for
screenshots is automatically deactivated.
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022