Figure 12: Dimensions Of The Rear Panel - HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual

II
2.1 Overview
This chapter describes the mounting of the product. It contains instructions about
how to correctly mount the product on stands or holders.
2.2 Assembly of the product
General mounting information
The mount for the mounting variants is provided on the rear panel. The connection is
compatible with the VESA standard 100 mm x 100 mm.

Figure 12: Dimensions of the rear panel

The materials for attachment of the mounting variants on the device are included in
delivery.
You will also need the following:
Torx T20 screwdriver
Torx T25 screwdriver
Allen key, size 2.5 (Duo-Pos stand)
Materials for mounting on a supporting surface
64
The following steps must be performed only by qualified personnel.
Further information: "Personnel qualification", Page 15
The unit must be mounted to a stand or a holder to ensure the correct
and intended use of the product.
Information for OEM and Setup users | Mounting
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022