HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 287

Information for the Operator user | What to do if ...
Fault
Cycle start key lighting
does not work
Reversal during thread
cutting does not work
Automatic traversing to
the limit switch does not
work
Outside of software limit
switches
Emergency stop
Control voltage is missing
Connection to the network
is not possible
The connected USB mass
storage device is not
detected
The unit starts in recovery
mode (text only mode)
User login is not possible
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Cause of fault Correction of fault
Incorrect setting of
Autostart light
Incorrect setting of
Spindle sleeve final
position +/-
Incorrect setting
of Software limit
switches or Automat-
ic feed
Incorrect setting
of Software limit
switches
External peripherals
External peripherals
Defective connection
Incorrect settings of
the network
Defective USB connec-
tion
The type or format-
ting of the USB mass
storage device is not
supported
Firmware error during
startup
Password does not
exist
Check settings
Page 122
Check settings
Check settings
Page 119
Page 120
Check settings
Page 119
Conduct a systematic error
search
Conduct a systematic error
search
Check the cable and the
correct connection to X116
Check the network settings
Page 163
Check the correct position
of the USB mass storage
device in the port
Use another USB port
Use another USB mass
storage device
Format USB mass storage
device with FAT32
If this fault occurs for the
first time, switch the product
off and then on again
If the fault recurs, contact a
HEIDENHAIN service agency
As user with higher
permission level, reset the
password
Page 160
To reset the OEM password,
contact the HEIDENHAIN
service agency
III
Personnel
Qualified
personnel
Qualified
personnel
Qualified
personnel
Qualified
personnel
Qualified
personnel,
possibly OEM
Qualified
personnel,
possibly OEM
Qualified
personnel
Qualified
personnel
Qualified
personnel
Qualified
personnel
Qualified
personnel
Qualified
personnel
287