HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 75

Information for OEM and Setup users | Installation
3.5 Wiring switching inputs and outputs
Hazard when using switching inputs for safety functions!
If switching inputs for mechanical limit switches are used for safety functions,
severe injury or death can result.
Do not use the switching inputs for mechanical limit switches for safety
functions
Depending on the peripherals to be connected, the connection work may
need to be carried out by an electrical specialist.
Example: Safety Extra Low Voltage (SELV) exceeded
Further information: "Personnel qualification", Page 15
The product fulfills the requirements of standard IEC 61010-1 only if
the power to the peripheral devices is supplied from a secondary circuit
with current limitation as per IEC 61010-1
power limitation as per IEC 60950-1
secondary circuit as specified in UL1310.
In place of IEC 61010-1
standards DIN EN 61010-1, EN 61010-1, UL 61010-1 and CAN/CSA-C22.2
No. 61010-1 can be used, and, in place of IEC 60950-1
the corresponding sections of standards DIN EN 60950-1, EN 60950-1,
UL 60950-1, CAN/CSA-C22.2 No. 60950-1 can be applied.
Wire switching inputs and outputs in accordance with the following pin layout
Remove and save the dust protection cap
Route the cables depending on the mounting variant
Further information: "Assembly of the product", Page 64
Connect the connecting cables of the peripherals tightly to their connectors
Further information: "Device overview", Page 71
If the cable connectors include mounting screws, do not overtighten them
The digital or analog inputs and outputs must be assigned in the device
settings of the respective switching function.
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
WARNING
, Section 9.4 or with
3rd Ed.
, Section 2.5 or from a Class 2
2nd Ed.
, Section 9.4, the corresponding sections of
3rd Ed.
, Section 2.5,
2nd Ed.
II
75