Block Types; Positioning; Coordinate Systems - HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual

Information for the Operator user | Programming
4.2

Block types

You can use the following block types for programming:
Positioning functions
Change of coordinate system (preset)
Machine functions
Machining cycle
4.2.1

Positioning

You can manually define position values for positioning. Depending on the
configuration of the connected machine tool, you can then move the tool to these
positions either automatically or manually.
The following parameters are available:
Positioning block type
Parameter
4.2.2

Coordinate systems

To change a coordinate system, you can call presets from the preset table. The
coordinate system of the selected preset will then be used after the call.
Further information: "Setting a position as a preset", Page 228
Preset block type
Parameter
Preset number
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Actual position
Applies the current axis position to the input fields of the
various block types
Description
Incremental position value, i.e. the position value is refer-
enced to the actual position
Description
ID from the preset table
Optional: Selection from preset table
III
255