HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 184

II
Parameter
Digits before the decimal point
for size-adjusted axis display
Simulation window
Radial machining axes
7.2.4
Simulation window
Settings ► General ► Display ► Simulation window
Parameter
Line thickness of tool position
Color of tool position
Line thickness of current
contour element
Color of current contour
element
Tool path
Tool always visible
Horizontal alignment
184
Information for OEM and Setup users | Settings
Explanation
The number of digits in front of the decimal point indicates the
size at which the position values are displayed. If the number of
digits in front of the decimal point is exceeded, then the display is
reduced in size so that all of the digits can be shown.
Setting range: 0 ... 6
Default value: 3
Configuration of the simulation window for MDI mode and
program run.
Further information: "Simulation window", Page 184
Display of the radial machining axis
Settings:
Radius
Diameter
Default value: Radius
Explanation
Line thickness for displaying the tool position
Settings: Standard or Bold
Default value: Standard
Definition of the color for displaying the tool position
Setting range: Color scale
Default setting: Orange
Line thickness for displaying the current contour element
Settings: Standard or Bold
Default value: Standard
Definition of the color for displaying the current contour element
Setting range: Color scale
Default setting: Green
Use of the tool path
Settings: ON or OFF
Default value: ON
The tool is always visible in the simulation window. The contour
and the current position of the tool are shown. The area is scaled
during the procedure
Settings: ON or OFF
Default value: OFF
Horizontal orientation of the coordinate system in the simulation
window
Settings:
Rightward: Values increase to the right
Leftward: Values increase to the left
Default value: Rightward
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022