Figure 17: Product Mounted On Multi-Pos Stand; Figure 18: Cable Routing On Multi-Pos Stand - HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual

Information for OEM and Setup users | Mounting
2.2.3 Mounting on Multi-Pos stand
Use the provided M4 x 8 ISO 14581 countersunk head screws (black) to fasten
the stand to the VESA 100 threaded holes on the rear panel
Comply with the permissible tightening torque of 2.6 Nm
Using two M5 screws, you can also optionally screw the stand to a supporting
surface from the bottom
Adjust the desired angle of inclination within the tilting range of 90°
To fix the stand: Tighten the T25 screw
Comply with the tightening torque for screw T25
Route the cable from behind through the two supports of the stand and then
through the lateral openings to the connections
Figure 17: Product mounted on Multi-Pos
stand
Further information: "Product dimensions with Multi-Pos stand", Page 217
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Recommended tightening torque: 5.0 Nm
Maximum permissible tightening torque: 15.0 Nm

Figure 18: Cable routing on Multi-Pos stand

II
67