HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 150

II
Configuring error messages
The OEM-specific error messages can be gated to inputs as additional messages.
The error messages will then be displayed when the input is activated. For this to
work, you need to assign the error messages to the desired input signals.
Settings ► Service ► OEM area ► Settings ► Messages
Parameter
Name
Text ID or text
Message type
Input
Remove the entry
4.8.7 Backing up and restoring OEM settings
All settings of the OEM area can be backed up as a file so that they are available
after a reset to the factory default settings has been performed or for installation on
multiple units.
The settings for the OEM area can be backed up as a ZIP file on a USB mass storage
device or connected network drive.
Settings ► Service ► OEM area ► Back up and restore
Parameter
Back-up OEM-specific folders
and files
Restore OEM specific folders and
files
150
Information for OEM and Setup users | Commissioning
Explanation
Description of the message
Selecting the message to be displayed. You can enter a Text
ID and thus select a message text that is available in your text
database. As an alternative, you can directly enter a new message
text
If you change the user language of the device, the
translations of the message texts from the text
database are used. For directly entered texts, no
translation is shown.
Further information: "Creating a Text database", Page 149
Selecting the desired type of message
Settings:
Standard: The message is displayed as long as the input is
active
Acknowledgment by user: The message is displayed until the
user acknowledges it
Default value: Standard
Assignment of the digital input according to pin layout to show the
message
Default value: Not connected
Removing the message entry
Explanation
Backing up the settings of the OEM area as a ZIP file
Restoring the settings of the OEM area as a ZIP file
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022