Information for the Operator user | MDI mode
2.2
Defining the upper limit for the spindle speed
If the product is configured with a spindle axis S, then you must define an upper
limit for the spindle speed prior to a possible machining sequence.
For this purpose, the Upper limit for spindle speed appears every time the product
is switched on.
Figure 40: Upper limit for spindle speed dialog box
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Tap the Maximum spindle speed input field
Enter the upper limit for the spindle speed with respect to the
currently used clamping equipment
Confirm your input with RET
Tap Confirm
The upper limit is now adopted by the product
The Upper limit for spindle speed dialog box is closed
III
235