HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 44

I
3.10 Status bar
In the status bar, the product shows the feed rate and traversing speed. The
operating elements of the status bar also give you direct access to the preset table
and tool table, as well as to the stopwatch and calculator features.
3.10.1 Operating elements of the status bar
The status bar provides the following operating elements:
Operating element
44
The status bar and the optional OEM bar are not available in the
Programming menu.
Function
Quick access menu
Setting of the units for linear values and angular values,
configuration of a scaling factor, configuration of the
position display for radial machining axes; tapping opens the
quick access menu
Further information: "Adjusting settings in the quick access
menu", Page 45
Preset table
Display of the current preset; tapping opens the preset table
Further information: "Creating a preset table", Page 168
Tool table
Display of the current tool; tapping opens the tool table
Further information: "Creating a tool table", Page 166
Stopwatch
Time display with Start / Stop function in h:mm:ss format
Further information: "Stopwatch", Page 47
Calculator
Calculator with the most important mathematical functions,
speed calculator and taper calculator
Further information: "Calculator", Page 47
Feed rate
Display of the current feed rate of the fastest linear axis
If all linear axes are at a standstill, the feed rate of the fastest
rotational axis is shown
In Manual operation and MDI mode, you can set the feed-
rate value; tap to open the dialog
Jog increment
Entering the jog increment and activating the jog increment
function in Manual operation mode; tap to open the dialog
If this function is active, a corresponding icon is shown
General information | Basic operation
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022