HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 130

II
Motor type: Stepper motor
Parameter
Output for stepper motor
Minimum step frequency
Maximum step frequency
Direction signal is inverted
Smax
Drive enable
Inputs (S)
Settings ► Axes ► S ► Inputs
Parameters
Movement commands from
digital input
Digital enable inputs
Spindle speed display via analog
input
130
Information for OEM and Setup users | Commissioning
Explanation
Assignment of the stepper motor output according to pin layout
Default value: Not connected
Definition of the minimum step frequency of the connected
stepper motor
Setting range: 0 kHz ... 1000 kHz
Default value: 0.000
Definition of the maximum step frequency of the connected
stepper motor
Setting range: 0 kHz ... 1000 kHz
Default value: 20.000
Activate this function if you want to change the direction of
rotation of the connected stepper motor
Default value: Not active
Definition of the Spindle speed attained at Umax
Setting range: 1 rpm ... 10000 rpm
Default value: 2000
Further information: "Special settings", Page 123
Assignment of the digital output for the drive enable according to
pin layout
Default value: Not connected
Explanation
Configuration of the movement commands for the digital spindle
input; e.g., jog buttons for spindle start and spindle stop
Configuration of the digital inputs for the spindle enable
Configuration of the display of the actual speed; assign the input if
the actual speed is to be displayed; indication of the spindle speed
at an input voltage of 5 V
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022