HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 101

Information for OEM and Setup users | Commissioning
Create table of supporting points
Path:
Settings ► Axes ► <Axis name> ► Error compensation ►
Segmented linear error compensation (SLEC) ► Create table of supporting points
Parameters
Number of supporting points
Spacing of the supporting points
Start point
Create
Enter the compensation value (D) "0.0" for supporting point 0
Enter the measured compensation values into the compensation value (D) input
field for each supporting point created
Confirm the entries with RET
Create table of supporting points
Settings ► Axes ► <Axis name> ► Error compensation ►
Segmented linear error compensation (SLEC) ► Create table of supporting points
Parameters
Number of supporting points
Spacing of the supporting points
Start point
Create
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022
Explanation
Number of supporting points on the mechanical axis of the
machine
Setting range: 2 ... 200
Default value: 2
Spacing of the supporting points on the mechanical axis of the
machine
Default value: 100.00000
The start point defines the position starting from which the
compensation is applied to the axis
Default value: 0.00000
Creates a new table of supporting points based on the entries
Explanation
Number of supporting points on the mechanical axis of the
machine
Setting range: 2 ... 200
Default value: 2
Spacing of the supporting points on the mechanical axis of the
machine
Default value: 100.00000
The start point defines the position starting from which the
compensation is applied to the axis
Default value: 0.00000
Creates a new table of supporting points based on the entries
II
101