HEIDENHAIN POSITIP 8000 Series Operating Instructions Manual page 134

II
Assigning and adjusting the handwheel
Now you assign the handwheel to the axis you want to move and define the settings
for the handwheel. Adapt these values based on the requirements of your machine.
Settings ► Axes ► X, Y ... ► Inputs ► Movement commands from electronic
handwheel
Parameter
Enable movement commands
from electronic handwheel
Selection of the electronic
handwheel
Invert the counting direction
Calculation of the feed override
in handwheel mode
Calculation of nominal feed rate
in handwheel mode
Position difference per
revolution
Maximum position difference
Resolution
Permissive button for movement
commands from electronic
handwheel
134
Information for OEM and Setup users | Commissioning
Explanation
Enabling of movement commands from an electronic handwheel
Settings: ON or OFF
Default value: OFF
In the drop-down list, select the electronic handwheel you want to
use
Activate this function if you want to invert the counting direction
When the function is active, the current feed-rate override is taken
into account in a handwheel movement
When the function is active, the currently entered feed feed rate is
taken into account in a handwheel movement
Entry of the position difference per revolution. This parameter
defines the linear movement per handwheel revolution
Setting range: 0.001 mm ... 8000 mm
Default value: 2.5
Entry of maximum position difference. This parameter allows you
to limit the buffer that the handwheel has built up for traversing
the linear axis
Setting range: 0.005 mm ... 20000 mm
Default value: 20
Entry of the electronic handwheel resolution for defining how
the electronic handwheel should move the axis. This parameter
defines how fine or coarse the axis movement will be
Setting range: 1 µm ... 65000 µm
Default value: 1
Assignment of the digital input for activating the electronic
handwheel
HEIDENHAIN | POSITIP 8000 | Operating Instructions Turning | 03/2022