Commands
For information about...
show webview
set webview
show ssl
set ssl
show webview
Use this command to display WebView status.
Syntax
show webview
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display WebView status:
B3(rw)->show webview
WebView is Enabled.
set webview
Use this command to enable or disable WebView on the switch.
Syntax
set webview {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
Enable or disable WebView on the switch.
show webview
Refer to page...
3-53
3-53
3-54
3-54
SecureStack B3 Configuration Guide 3-53
Need help?
Do you have a question about the SecureStack B3 and is the answer not in the manual?