Update The Software - Magtek ExpressCard 2000 Hardware Service Manual

3 - Preventive Maintenance Procedure (EC2000)
3.4

Update the Software

If MagTek Support Services has supplied .CAB files to apply EC2000 software patches, follow these
steps to install them:
1) Use the Ethernet cable to connect the service laptop to EC2000. If necessary, you may instead use
the customer's instant issuance workstation, provided it has Microsoft Internet Explorer and a USB
port with security settings that allow you to read from the USB thumb drive.
2) Launch the Internet Explorer web browser and navigate to https://ec-xxxxxxx, where xxxxxxx is the
device's serial number. The browser should show an
3) Open the
Software Upload
Browse...
4) Press the
5) Navigate to the folder that contains the .CAB files you want to apply (such as the field service
laptop's hard drive or the USB thumb drive).
6) Select the .CAB file you want to apply, and press the
page.
7) Press the button to upload the .CAB file to the device. The browser will display a status
Send
message telling you when the patch will be applied (for example, "File Copied Successfully. Update
will be performed during next reboot."). The device's touchscreen may also go blank.
8) Restart the device by powering it off, then powering it on. Wait until the touchscreen once again
displays the ExpressCard 2000
9) In the web browser, open the
"SUCCESS," repeat these steps for any additional patch .CAB files you need to apply, or continue to
the next section.
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
link on the left side of the page to display a
button to launch the Choose File to Upload
page.
Status
Upload Status
Page 41 of 356 (D99875607-91)
ExpressCard 2000
dialog box.
Open button to return to the
link on the left side of the page. If the browser reports
web interface page.
page.
File to Upload
File to Upload