Update The Software - Magtek ExpressCard 3000 Preventive Maintenance Procedure

3 - Preventive Maintenance Procedure (EC3000)
3.4

Update the Software

If MagTek Support Services has supplied .CAB files to apply ExpressCard software patches, follow these
steps to install them:
1) Use the Ethernet cable to connect the service laptop to the ExpressCard. If necessary, you may
instead use the customer's instant issuance workstation, provided it has Microsoft Internet Explorer
and a USB port with security settings that allow you to read from a USB thumb drive.
2) Launch the Internet Explorer web browser and navigate to https://ec-xxxxxxx, where xxxxxxx is the
device's serial number. The browser should show an
3) Open the
Software Upload
Browse...
4) Press the
5) Navigate to the folder that contains the .CAB files you want to apply (such as the field service
laptop's hard drive or the USB thumb drive).
6) Select the .CAB file you want to apply, and press the
page.
7) Press the button to upload the .CAB file to the device. The browser will display a status
Send
message telling you when the patch will be applied (for example,
Update will be performed during next reboot.
8) Restart the device by powering it off, then powering it on. Wait until the touchscreen once again
displays the ExpressCard 3000
9) In the web browser, open the
SUCCESS , repeat these steps for any additional patch .CAB files you need to apply, or continue to
the next section.
ExpressCard 3000| Instant Issuance Card Personalization System | Preventive Maintenance Procedure
link on the left side of the page to display a
button to launch the Choose File to Upload
page.
Status
Upload Status
Page 12 of 24 (D998200294-10)
ExpressCard 3000
dialog box.
Open button to return to the
File Copied Successfully.
). The device's touchscreen may also go blank.
link on the left side of the page. If the browser reports
web interface page.
page.
File to Upload
File to Upload