How To Use The Mcp Commands Page - Magtek ExpressCard 2000 Hardware Service Manual

2 - Introduction

2.9.1 How to Use the MCP Commands Page

The move the various parts of the ExpressCard individually, rather than as part of a standard sequence,
use the touchscreen to navigate to
Commands page. Note that the
damage the device -- think carefully before sending a direct move command!
Table 2.1 provides an
MCP Commands
movement, in addition to moving a card from hopper 1 to the output bin. You can test by pressing each
button in the list and verifying the described action happens correctly. The gray highlighted rows are a
shorter sequence that also moves a card from hopper 1 to the card output bin.
Table 2.1 - Controller Buttons and Corresponding Movements
Press This Button
Pusher Home
8 To Hopper
7 To Hopper
6 To Hopper
5 To Hopper
To Manual Feed
4 To Hopper
3 To Hopper
Shuttle Home
2 To Hopper
1 To Hopper
Bot Cartridge Unload
Indenter Move
,
Bot Cartridge Load
Indenter Move
Bot Cartridge Home ,
Indenter Move
Bot Cart to Indent Loc.
Indenter Move
Bot Ribbon Advance
Indenter Move
Top Cartridge Unload
Indenter Move
,
Top Cartridge Load
Indenter Move
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Menu > Settings
MCP Commands
sequence that exercises the device's complete range of
Hopper shuttle's pusher moves into safe position for move
Hopper shuttle moves to (or stays at) manual feed slot, slot light flashes
Hopper shuttle moves to (or stays at) hopper 1, slot light stops flashing
Hopper shuttle moves to (or stays at) hopper 1
Hopper shuttle moves to (or stays at) hopper 1
Hopper shuttle moves to (or stays at) manual feed slot, slot light flashes
Hopper shuttle moves to (or stays at) hopper 1
Hopper shuttle moves to (or stays at) hopper 1
Hopper shuttle moves near hopper 1
Hopper shuttle moves to (or stays at) hopper 1
Hopper shuttle moves to (or stays at) hopper 1
,
Rear (black) indent cartridge moves out of embosser toward rear of device
Rear (black) indent cartridge moves back into embosser
Rear (black) indent cartridge moves back into (or stays in) embosser
,
Rear (black) indent cartridge moves between letters on embosser wheel
,
Ribbon in rear (black) indent cartridge advances by about ¼"
,
Only if testing ExpressCard with Front Indenter installed:
Front (white) indent cartridge moves out of embosser toward rear of device
Only if testing ExpressCard with Front Indenter installed:
Front (white) indent cartridge moves back into embosser
Page 25 of 356 (D99875607-91)
> Service > MCP Commands
page may allow you to make moves that could
Verify This Happens
to open the MCP