How To Handle Esd-Sensitive Parts - Magtek ExpressCard 2000 Hardware Service Manual

2 - Introduction
2.3

How to Handle ESD-Sensitive Parts

To prevent electrostatic discharge (ESD) damage to electronic parts, follow the
instructions below:
 Keep ESD-sensitive parts in their original shipping containers until you are ready to
install them.
 When handling ESD sensitive parts, prevent static discharge by moving around as
little as possible. Static charges are produced by rubbing together clothing, carpets,
furniture, etc.
 Wear an ESD wrist strap connected to a metal part on the device's chassis, such as the
base plate. This will discharge static electricity from your body.
 Hold ESD-sensitive parts by their edges or their mounting trays. Do not touch their
pins or circuitry.
 Do not place an ESD-sensitive part on the device or on a metal table; put it in an ESD
bag or on an ESD mat.
 Use extra caution when working under climate conditions that increase the potential
for ESD, such as cold weather or low humidity.
ExpressCard 2000 / ExpressCard 3000| Instant Issuance Card Personalization System | Hardware Service Manual
Page 19 of 356 (D99875607-91)